Tips to finding the perfect grip

[Terri_O]

When purchasing a gun you often hear from others to find one that feels good to you. As if you can judge how you a gun will work for you just based on how it feels in your hands. Here is an interesting article with some key points to look for when purchasing a gun.

http://www.luckygunner.com/lounge/how-to...a-handgun/

[Mikey]

A few of years ago, I read a short blog post by Todd Green
entitled “Feelings”. It was about how it’s easy to trick ourselves into
believing that one particular technique or piece of gear is effective
based on how it “feels” to us. Todd used the example of adding a
GripForce Adapter to his Glock. The grip didn’t feel as good in his
hands as the unmodified Glock, but his range performance was measurably
better with it than without it. The point was that without objective
methods of measurement like timers and targets, our feelings lie.

This article has really stuck with me and I’ve noticed the same bias
in myself and other shooters. The grip example is not the only area
where the “feelings lie” mantra applies, but it’s a common one in the
shooting world. As a community, we tend to place a lot of emphasis on
the way a particular handgun “feels” in our hands. That’s because if we
can’t actually shoot the gun, or can’t/don’t measure and track our
performance objectively, the feel of a pistol when it meets our firing
hand is one of the only indications we have of whether we like the gun
or not.

No article about handgun grips would be complete without a photo of a 1911. So here it is.
I appreciate that “melts into your hand” feeling of an ergonomically
sound handgun grip as much as anyone, and it’s not a bad thing in
itself. However, since being clued into this phenomenon, I’ve learned to
downplay the importance of how a grip feels. When I first started
shooting M&P pistols on a regular basis, I really thought the grip
fit my hands perfectly when using the smallest of the three backstrap
inserts that come with the gun. Then I tried adding a Crimson Trace
Laser Grip. It felt huge in comparison, and I hated it at first. But
timing some drills at the range showed virtually no change in speed or
accuracy in daylight hours and, thanks to the laser, a huge improvement
in dim lighting. The correlation between a grip that feels “perfect” and
optimal performance on the range is inconsistent at best.

I’ve also had to alter the way I respond to people who ask my advice
when shopping for a handgun. After getting an idea of the person’s
situation, I used to offer a handful of suggestions and tell them
to “try to handle as many as possible and just pick whichever one feels
best in your hands.” But if I can’t tell whether a grip that
“feels right” is actually going to work for me, how is a complete novice
shooter supposed to figure it out in a gun store?

Fortunately, there are some red flags to look out for when checking
out handgun grips that don’t require you to measure your performance at
the range in order to rule them out. Your feelings can lead you astray,
but if the gun actually prevents you from achieving a proper firing
grip, then something will have to be changed, or you’ll need to try a
different model. Here are a few common grip problems that can prevent
you from shooting a handgun well.

1. Unable to Reach Controls

At minimum, you should be able to reach the magazine release and safety lever (if applicable) on a semi-auto without altering your firing grip.
Ideally, you should also be able to reach the slide lock lever but the
off-hand thumb can also be used, or just stick with the slide rack method on reloads.
Even if you have small hands, you should be able to find a handgun that
doesn’t require you to shift your hand position in order to activate
the safety.

The Sig P238 is a nice shooting gun if you can find a place for your hands.
It’s not just folks with small hands who have to watch out for this,
though. If you have large, or even medium-sized hands, some of the
controls on the smaller semi-autos can be tough to reach. It’s not
uncommon for the safety lever to be placed in an awkard to reach
position. You might be able to work around these issues with some
practice, but in some cases, the position of the controls might be
almost impossible to access if you have a good firing grip on the gun.
As a personal example, I have a really hard time finding a place for my
support hand on the Sig P238 where my thumb doesn’t interfere with the
slide stop lever.

2. Grip Too Wide

If you’ve had any kind of basic handgun training at all, you’ve probably seen an image like this:



Your forearm should be in a straight line with the gun, like the
image on the left. This allows the recoil to be absorbed by your arm and
into your body. If the grip is too wide, you’ll be forced to shift your
hand over like the image in the right. Then, gun isn’t aligned with
your forearm and the recoil will go into your thumb and hand instead.
Not only does this prevent adequate control, it can also be very
painful. Sometimes a grip like this is simply the result of improper
technique, but if the grip is too large for your hands, it will be
impossible to correct without physically altering the gun or trying a
different handgun model altogether.

3. Trigger Reach Too Long

This one usually goes along with the grip thickness issue. Sometimes the grip might not feel
too large, but if you can’t get sufficient leverage on the trigger,
you’ll end up shifting your grip like in the above example in an attempt
to compensate.

I
prefer the Vertec version of the Beretta 92 because the reduction of
bulk on the backstrap allows a much shorter trigger reach.
This is an especially common problem with heavier double action
triggers like revolvers and traditional double action semi-autos. In
fact, I think trigger reach is one of the reasons people seem to have
such a “love it or hate it” attitude toward the Beretta 92FS, which has a
somewhat long trigger reach in its stock form.

4. Finger Grooves

For some reason, gun manufacturers love to install finger grooves on
handgun grips, but serious shooters tend to shy away from them. They’re
found in the form of the subtle grooves on the gen 3 and gen 4 Glocks
all the way up to the massive canyon-sized grooves on the ubiquitous
Hogue revolver monogrips.

Left:
The firing hand position on a revolver should be as high as possible on
the backstrap to allow optimal control over recoil. Unfortunately, with
my hand in this position, my fingers line up with the raised portion
between the finger grooves on this particular set of grips. Right: If I
align my fingers with the grooves, my hand is forced lower down on the
backstrap, sacrificing control.
Anyone can grab one of these grips and place their fingers inside the
pre-formed recesses, and it might even feel pretty comfortable. But
that doesn’t mean you’ll have a correct firing grip. For many people,
placing their fingers in the grooves will force the hand to be too low
on the grip to have sufficient control of the gun under recoil.
Conversely, placing the hand in the correct position might necessitate
that the fingers wrap around the ridges on the front of the grip, rather
than inside the grooves. If the grooves are subtle enough, the shooter
might be able to ignore this minor discomfort, but it can also cause
pain or loss of control under recoil.

5. Grip Length Too Short

The effect of grip length on shooting performance can vary a lot from
one gun to the next, so this one might actually require some trial and
error more than the others. With semi-auto pocket guns and small
revolvers equipped with short “boot grips” it’s very common for the
pinky to have trouble finding a home on the grip. If the gun doesn’t
recoil much, this might not be a deal breaker. The middle and ring
finger are doing most of the work anyway.

Because
of the low recoil, I haven’t found much difference in performance when
shooting the Glock 42 with and without the grip extensions installed on
the magazines. However, the longer grip does allow for a quicker and
much more consistent draw stroke.
That said, I still wouldn’t recommend a gun that requires this kind
of grip for an inexperienced shooter. And even if you have solid
technique, some of the small autos have stiff enough recoil that you’ll
want as many fingers on the grip as you can get. Fortunately, magazine
grip extenders and longer revolver grips are available for almost every
small handgun model in current production, so it’s an easy fix.

These tips are most useful for helping novice shooters avoid a
handgun with a grip that will hinder them from learning the
fundamentals . In general, it’s really not that difficult to find a
handgun with a grip that’s at least adequate. As your skill level
develops, it takes more trial and error to figure out which attributes
of a handgun grip you can tweak to help maximize your performance